Aluminium is very commonly used. It isn’t near as good a conductor as copper, but you can easilly use more toeget results and in most cases that works fine.
The reason we stopped using aluminimun more is it is relly tricky. when you tighten a screw the al deforms over time and so you don’t get a lasting connection. Al also corrodes to a non conductive state. Many house fires were traced to al wiring in just the few years it was common. We can mitigate all the above issuses but it takes care and so copper is preferred despite al being much cheaper.
They stopped putting aluminum in homes, because it has a tendency to overheat more. The aluminum expands and contracts with load more than copper, which can loosen contact points and encourage oxidation, which then increases resistance and heat. Hot wires in the walls and outlet boxes are no bueno.
I’m not defending the article, but I think most overhead power lines are aluminium, which is probably good as it’s abundant compared to copper.
Aluminium is very commonly used. It isn’t near as good a conductor as copper, but you can easilly use more toeget results and in most cases that works fine.
The reason we stopped using aluminimun more is it is relly tricky. when you tighten a screw the al deforms over time and so you don’t get a lasting connection. Al also corrodes to a non conductive state. Many house fires were traced to al wiring in just the few years it was common. We can mitigate all the above issuses but it takes care and so copper is preferred despite al being much cheaper.
Aluminium conducts better per weight. Copper per volume.
https://en.m.wikipedia.org/wiki/Electrical_resistivity_and_conductivity
They stopped putting aluminum in homes, because it has a tendency to overheat more. The aluminum expands and contracts with load more than copper, which can loosen contact points and encourage oxidation, which then increases resistance and heat. Hot wires in the walls and outlet boxes are no bueno.
deleted by creator