I have a bed that looks like this, doesn’t have legs.
I was looking at bed risers, but they’re aimed for beds with legs. Also, the risers make the bed rise too high for my needs.
I only need to make the bed rise for about 2-inches so I can use an overbed table like
.
Probably be easier to remove 2 inches from the table. Take to a welder and have them cut a chunk out of the middle.
I think the issue is that the base is supposed to be able to go under the bed to bring the table part over the bed.
The legs of the table need to go under the bed.
Currently there’s zero space under the bed, that’s why I need something similar to a riser.
Oh the ones at hospitals swivel around so they can go next to things.
Can you take the tube out and rotate it 180 degrees?
You would have to watch the balance a lot though
This isn’t a terrible idea like I initially thought. Permanently attach a heavy counterweight to the base of the overbed table and it’ll be more stable.
I’m hoping OP will be able to find an overbed table for situations where sliding the base under the bed isn’t possible. They can’t be the first person in the world with this problem.
Without the base being under the table it is just a lever. Sure, people run into this, but you basically need a large and solid frame off to the side to keep it from tipping.
I think if you put a 50 pound barbell plate on there it would be pretty secure
Placed at the very end it would be evenly balanced at 50 lbs. It would be OK around 20ish lbs that didn’t move, but a little weight plus setting things down would make it wiggle and possibly tip since something moving down has more force than the object itself.
2 plates? The solution is easily scaled up. Lol
That table telescopes. Looks like it already has a way to adjust?
In any case, you could also add feet to the bed. I’d drop examples, except without knowing more about how the bed is made, the specifics get a bit wonky
Another option is taking a couple 4x4’s and trimming them down to the right height and setting them out in a frame- bed on top. (2x4’s are not quite 2”, but if those are thick enough, even simpler,)