Nissan is recalling more than 480,000 of its vehicles across the U.S. and Canada due to potential manufacturing defects that could cause engine failure.
As a remedy, the NHSTA’s recall report notes, Nissan and Infiniti dealers will inspect the engine pan of these-now recalled cars — and repair or replace the engine if necessary.
But your shit quality process already admits that failure is progressive. What are you going to do for customers who get a failure years later because of your bad manufacturing?
It sounds like they are inspecting the oil pan for signs of metal shavings indicative of possible metal loss from engine bearings.
It should be progressive because if you shave off enough metal, the bearing will completely fail.
If there are no metal shavings in your oil, then the issue should not progress because it is not present.
You should replace the bearings if faulty and there is no other damage. Otherwise, you should replace the engine.
Interestingly, the recall report states that the ECM of the 3L engine will be reprogrammed but the 4L will only have the oil replaced if they are found to be good engines?
Are they decreasing performance on 3L engines to match the lower than expected performance of the bad bearings so the engine doesn’t fail?
But your shit quality process already admits that failure is progressive. What are you going to do for customers who get a failure years later because of your bad manufacturing?
Answer: nothing!
It sounds like they are inspecting the oil pan for signs of metal shavings indicative of possible metal loss from engine bearings.
It should be progressive because if you shave off enough metal, the bearing will completely fail.
If there are no metal shavings in your oil, then the issue should not progress because it is not present.
You should replace the bearings if faulty and there is no other damage. Otherwise, you should replace the engine.
Interestingly, the recall report states that the ECM of the 3L engine will be reprogrammed but the 4L will only have the oil replaced if they are found to be good engines?
Are they decreasing performance on 3L engines to match the lower than expected performance of the bad bearings so the engine doesn’t fail?