It always wants to ride up the sides of my bed because elastic never wants to hold it in place. When I wash and dry my sheets it inevitably spirals up in the washer and dryer so it never washes or dries properly. Then it’s a pain in the ass to try and fold neatly.

I feel like I’m failing adulthood after being bested by a bedsheet.

  • hperrin@lemmy.world
    link
    fedilink
    arrow-up
    37
    ·
    7 months ago

    If it’s riding up the sides of your mattress, it’s probably not big enough for your mattress. Sheets say on the package something like, “fits mattresses up to 11 inches tall”. If your mattress is taller than that, it’ll ride up.

  • Dr. Wesker@lemmy.sdf.org
    link
    fedilink
    English
    arrow-up
    21
    ·
    edit-2
    7 months ago

    4-point suspenders. The adjustable kind for big boys.

    Lay it on your box spring, with the 4 clips pointing at the 4 corners of the bed. Lay your mattress back down. Put your fitted sheet on, and clip each suspender clip to each corner of the sheet, under the mattress.

    Life hack you didn’t know you needed.

      • Dr. Wesker@lemmy.sdf.org
        link
        fedilink
        English
        arrow-up
        6
        ·
        edit-2
        7 months ago

        Firemen and obese truckers.

        To answer your question in two parts:

        1. I do own a pair or two of nice dress suit suspenders, and they’re awesome. The nice kind, where you have to get buttons sewn into your dress slacks.

        2. I did specifically buy a pair of firemen suspenders, for use with sheets.

      • lukewarmtuna@lemmy.world
        link
        fedilink
        arrow-up
        5
        ·
        7 months ago

        My grumpy 67 yo coworker has been wearing 3 point suspenders for the past week, never seen him wear em before

  • elbowgrease@lemm.ee
    link
    fedilink
    arrow-up
    19
    ·
    7 months ago

    there trick is to pull the elastic down far enough so it reaches over the bottom edge of the mattress.

    forget folding it neatly. you can adult without that skill

  • The Dark Lord ☑️@lemmy.ca
    link
    fedilink
    arrow-up
    10
    arrow-down
    1
    ·
    7 months ago

    Glue it to your bed. To wash, hose it down every few months. It takes about a week to dry the mattress, so you just have to get used to sleeping on a damp surface. Apply Febreze liberally.

  • ColeSloth@discuss.tchncs.de
    link
    fedilink
    arrow-up
    8
    ·
    7 months ago

    Buy nicer sheets and you may need to buy the ones made for a deep mattress.

    As a last resort you can buy clip on sheet holders that will make sure they won’t come off, but at some point you’ll probably end up ripping your sheet if you use them.

  • mr_robot@lemmy.worldOP
    link
    fedilink
    English
    arrow-up
    6
    ·
    7 months ago

    This is a cool community. I never expected so many helpful replies to this. Thank you all.

  • THCDenton@lemmy.world
    link
    fedilink
    arrow-up
    6
    ·
    7 months ago

    I’m currently laying in a crumpled up mess of sheets that came off the corners. This is my life now.

  • They sell elastic with clips you can use to hold your sheets in place. They’re a pain in the ass to switch if you don’t know how.

    My technique is to stretch the clean fitted sheet over the old one and move the clips one side at a time, then pull out the old sheet from under it.

  • kirklennon@kbin.social
    link
    fedilink
    arrow-up
    6
    ·
    edit-2
    7 months ago

    Mattresses have an enormous variance in thickness, and sheets vary considerably in the depth of the “pocket.” If your sheets can barely fit over a too-thick mattress, then they’re going to pop off when you move on them. You might just want to buy some new sheets with a deeper pocket. Alternatively, you can buy elastic straps that go under the bed and clip onto the sheets. You’ll generally either find these as a four pack of short ones that are meant to go only at the corners, or as a two pack of long ones meant to stretch under the entire bed and attach opposite sides. Get the long ones; they generally perform much better.

  • Lmaydev@programming.dev
    link
    fedilink
    arrow-up
    6
    ·
    edit-2
    7 months ago

    There should be enough give to tuck the corners and sides underneath your mattress.

    If not you may need deeper sheets.

    I just fold them corner to corner as normal and accept it’s shit haha

  • Ekky@sopuli.xyz
    link
    fedilink
    arrow-up
    4
    ·
    7 months ago

    Do you latch your sheets below your matress’ corners? They’re usually meant to fully cover the top and all sides, except for those with no elastic.

    Or, perhaps the elastic has gotten too lash, so they slip out from below and ride up the sides?

    I don’t have a proper solution for washing and drying, except putting them in a washing bag so they don’t eat all the other laundry.

    • mr_robot@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      7 months ago

      I do latch them below the corners. I have a foam mattress topper, so fitted sheets just fit around the mattress. As a result, there isn’t a lot of extra material to go under the mattress.

      I learned these straps exist. Going to give it a shot.

      • BombOmOm@lemmy.world
        link
        fedilink
        English
        arrow-up
        6
        ·
        edit-2
        7 months ago

        fitted sheets just fit around the mattress

        This is your core problem. They need to fit a good ways past the edge. You need a ‘deeper’ fitted sheet.