A severed mosquito proboscis can be turned into an extremely fine nozzle for 3D printing, and this could help create replacement tissues and organs for transplants.
I’ve linked to a decent write-up on Tom’s Hardware, but New Scientist covered it last week too.
Source paper: 3D necroprinting: Leveraging biotic material as the nozzle for 3D printing (science.org)
I’m only in favor of this if the mosquito suffers mightily somewhere along the process.
I want it setup so the hot filament goes into its asshole and then out through the probiscus.
Now there’s a mental image.
The process does involve gaslighting and lying to their mosquito family
No no. I want them to know it was me.
One almost killed me. Dengue.
Good news! Brazil developed a single dose vaccine against dengue!! I don’t know when they’re going to start vaccinating, but the vaccine has been approved, it’s already tested and everything!
I’m currently living somewhere hot enough that the little pricks are a bother all year round.
Why ja vol? Either ja, voll or jawoll.